Changing Gear Oil Or Filling Up After Performing Repairs - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
• The gear oil that has collected in the overflow pipe -arrow 2-
will drain off first.
Note
Regardless of the gear oil level, a certain amount of gear oil will
always drain off.
• The gear oil level is correct if a small amount of oil drains out
when the oil temperature is between 35 and 45 °C (the oil level
rises as the oil temperature continues to increase).
Note
Every 30 seconds a small surge of oil will come out of the
♦
overflow pipe, regardless of the oil level (this is caused by the
intermittent supply of cooling oil to the multiple clutch). This
surge of oil is not relevant when checking the gear oil level and
can be disregarded.
Do not re-use drained-off gear oil.
♦
Check the gear oil temperature on vehicle diagnostic, testing
♦
and information system -VAS 5051B- while filling the gearbox
with oil. Stop filling and allow the gearbox to cool down if the
temperature exceeds 45 °C.
– If gear oil level is OK
Final steps
• Tightening torques ⇒ page 66
Note
Renew seal -arrow- for inspection plug.
– Unscrew adapter for oil filling -VAS 6262- from gearbox.
– Tighten inspection plug -B-.
Note
-Item A- can be disregarded.
– Exit from function "011 - Measured values" by pressing
ton.
– Press "06 - End output".
– Switch off ignition and unplug diagnostic connector.
9.2 Changing gear oil or filling up after per‐
forming repairs
Special tools and workshop equipment required
72
Rep. Gr.34 - Controls, housing
⇒ page 72 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
but‐
←