Manual Release Of Selector Mechanism - Audi TT 2007 Workshop Manual

❑ Manual release of selector mechanism

❑ Removing and installing
10 - Detent spring
11 - Bolt
❑ 3.5 Nm
12 - Pivot pin
13 - Bolt
❑ 3.5 Nm
❑ 4 x
14 - Detent plate
15 - Cover for shift unit
❑ With glued-on gasket
16 - Nut
❑ 9 Nm
❑ 4 x
❑ Self-locking
❑ Renew
17 - Bracket
18 - Lock washer
❑ 2 x
19 - Locking plate
❑ Renew
3.1 Manual release of selector mechanism
In the event of failure of the supply voltage to the selector lever
lock solenoid (discharged battery or defective fuse), or if the sol‐
enoid itself is defective, the selector lever cannot be shifted out
of position "P". The vehicle then cannot be moved because the
parking lock is engaged.
Proceed as follows:
– Check fuses ⇒ Current flow diagrams, Electrical fault finding
and Fitting locations.
– Check battery voltage ⇒ Rep. Gr. 27 .
– If no fault is found in the supply voltage, release the selector
mechanism manually as follows:
– Using a small screwdriver, carefully pry selector lever boot out
of trim for selector lever boot -arrow 1-.
– Pull up both sides of boot and detach boot -arrows 2 and 3-.
– Turn selector lever boot inside out over selector lever handle.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
⇒ page 31
⇒ page 41
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
3. Servicing selector mechanism - exploded view
31