Removing And Installing Oil Pan - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Gear oil pump; tightening sequence
Note
There are different types of bolts -A or B-; observe correct tight‐
ening method.
– Tighten bolts -arrows- in diagonal sequence (different bolts
according to version):
Countersunk-head bolts -A-:
– Tighten countersunk-head bolts to 8 Nm.
Pan-head bolts -B-:
– Tighten pan-head bolts in 2 stages as follows:
1. Tighten bolts to 8 Nm.
2. Turn bolts 90° further.
Cover for gear oil pump -A-; tightening sequence
– Tighten bolts -arrows- diagonally in stages.
• 8 Nm
Gearbox input speed sender -G182- and clutch temperature
sender -G509-
A - Gearbox input speed sender -G182- and clutch tempera‐
ture sender -G509-
• Removing and installing
B - Bolt
• 10 Nm
C - Electrical connector
1.2

Removing and installing oil pan

Special tools and workshop equipment required
82
Rep. Gr.35 - Gears, shafts
⇒ page 89
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.