Rear Output Flange And Driveshaft Seal, Transfer Case Installing, Removing And Installing - Audi Q7 2007 Repair Manual
Transfer case 0bu, front final drive 0bm, 0c1 and 0bn, rear final drive 0bp
Hide thumbs
Also See for Q7 2007:
- Repair manual (414 pages) ,
- Workshop manual (228 pages) ,
- Repair manual (345 pages)
Table of Contents
Advertisement
Audi Q7 2007 ➤
Transfer Case 0BU, Front Final Drive 0BM, 0C1 and 0BN, Rear Final Drive 0BP - Edition 12.2012
5.4
Rear Output Flange and Driveshaft
Seal, Transfer Case Installing, Remov‐
ing and Installing
Special tools and workshop equipment required
♦ Puller - Unit Injector - T10055-
♦ Puller - Unit Injector - Adapter 2 - T10055/2-
♦ Seal Installer - Inner Output Shaft - T10399-
♦ Seal Installer - Flange Shaft - T10450-
♦ Sealing Grease - G 052 128 A1-
♦ Screw, approximately 4 mm diameter
♦ Pry lever approximately 600 mm (for example, Hazet 652-24)
Removing
Place a cloth over the bracket for the exhaust system.
– Remove the bolts from the intermediate bearing -1- and lay
the driveshaft on the exhaust system.
– If equipped, remove the balance weight from the transfer case
(4 bolts).
28
Rep. Gr.34 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Advertisement
Table of Contents
