Removing And Installing Gearbox Input Speed Sender G182 And Clutch Temperature Sender G509 - Audi TT 2007 Workshop Manual

– Tighten bolts for mechatronic unit for direct shift gearbox -
J743- ; note correct tightening sequence
– Engage electrical wire in top retaining tab first -arrow II-, then
in bottom tab -arrow I-.
– Attach connector for -G182- and -G509- , and check that it is
properly engaged.
– Install oil pan ⇒ page 82
– Attach electrical connector for mechatronic unit for direct shift
gearbox -J743- and turn retainer to secure connector.
– Install cover for gear oil pump
– Fill up with gear oil ⇒ page 72
⇒ page 72 .
– Connect vehicle diagnostic, testing and information system -
VAS 5051B- .
– Perform basic setting.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
1.4 Removing and installing gearbox input
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
speed sender -G182- and clutch tem‐ with respect to the correctness of information in this document. Copyright by AUDI AG.
perature sender -G509-
Removing
Proceed as follows:
Caution
Risk of damage to the gearbox.
♦ Do not run the engine or tow the vehicle with the oil pan
removed or when there is no gear oil in the gearbox.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
⇒ page 81
.
⇒ page 90 .
and check gear oil level
.
1. Oil pan, mechatronic unit, gear oil pump - exploded view
Audi TT 2007 ➤
89