Table of Contents
Advertisement
Upgrading MX240, MX480, and MX960 3D Universal Edge Router Power Supplies and Fan Trays
NOTE: After powering off a power supply, wait at least 60 seconds before turning it
back on.
To remove a DC power supply (see Figure 14 on page 16):
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Figure 14: Removing a DC Power Supply from the Router
Setting the MX240 and MX480 DC High-Capacity Power Supply Input Mode Switch
NOTE: Move the input switch to 0 for 60 A input and position 1 for 70 A input.
16
Setting the MX240 and MX480 DC High-Capacity Power Supply Input Mode Switch
Switch off the dedicated customer site circuit breaker for the power supply being
removed. Follow your site's procedures for ESD.
Make sure that the voltage across the DC power source cable leads is 0 V and
that there is no chance that the cables might become active during the removal
process.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to one of the ESD points on the chassis.
Move the DC circuit breaker on the DC power supply faceplate to the off (
position.
Remove the clear plastic cover protecting the terminal studs on the faceplate.
Remove the nut and washer from each of the terminal studs. (Use a
7/16-in. [11 mm] nut driver or socket wrench.)
Remove the cable lugs from the terminal studs.
Loosen the captive screws on the bottom edge of the power supply faceplate.
Carefully move the power cables out of the way.
Pull the power supply straight out of the chassis.
O
)
Advertisement
Table of Contents
