Rep 9.5 Developer Module - Xerox 8830 Service Manual

REP 9.5 Developer Module

Parts List on PL 9.8
WARNING
Switch off the Main Power Switch. Disconnect the
Power Cord.
NOTE: The art used for this procedure was
developed for previous products and may not match
the 8830 configuration exactly.
Removal
CAUTION
Before removing the Developer Module, ensure that
there is a clean area on which to place the assembly.
1. Loosen the screws and open the Rear Cover.
2.. Raise and latch the Top Cover.
3. Raise and hold the Developer Module Cover
while lifting and removing the Developer
Module Side Cover.
4. Lower the Top Cover.
NOTE: In the following step, tape the Toner
Cartridge dispense holes in order to prevent toner
from pouring out when the Toner Cartridge is tipped
up for removal
5. (Figure 1): Remove the Toner Cartridge.
3
Pull the plunger while
performing Step 4
1
Slide the cover
open
2
Clean the toner from the holes
in the dispense area and place a
piece of tape over the holes
Figure 1. Removing the Toner Cartridge
1/98
4-53
4
Remove the Toner
Cartridge
R1599A
REP 9.5