Delta AS Series Programming Manual page 955

AS Ser ies Pro gra mm in g M anu al
3. S is the communication function code, and S is the source or received data as explained in the following table.
3
S
3
function
code
0
1
2
3
4
5
6
_6
4. The following chart shows the timing for sending and receiving data.
Enable/disable t he exec ution
6 - 6 7 6
S function name
3
Reset due to abnormality
Clockwise running command
Counterclockwise running
command
Stop
Jog clockwise running
command
Jog counterclockwise running
command
Reading the state
of the instruction
Sending data
Rec eption fl ag
Receiv ing data
Compl etion fl ag
S source and received data
Unused
Velocity value
Velocity value
Unused
Unused
Unused
Received state values
 

Remark
Any value can be stored in S.
Refer to AC motor drive user
manual for the setting value and
the unit.
Any value can be stored in S.
Refer to AC motor drive user
manual for setting the jog
velocity.
Refer to AC motor drive user
manual for the meaning of the
state values of the 5 bit
addresses H2100–H2104 for
VFD.

