Delta AS Series Programming Manual page 1188

Start/end
frequency(Hz）
Ramp-up/down time
（ms）
Some flags, such as fixed slope ramp-up/down, and executing an interrupt program when pulse output ends, are
not supported by the odd output points.
If the output is ongoing, the preset output is the ramp-down stop when the instruction is disabled or stops
temporarily. If the output must be stopped immediately, set the immediately stop flag to ON.
7. For PLC with FW V1.06.00 or later, added new SR652, SR653 for displaying number of pulse in ramp-up area and
new SR654, SR655 for displaying number of pulse in ramp-down area.
Refer to the following table for Attribute, Factory default and latched values of SM/SR corresponding to the axes.
Item
Busy flag
Completion flag
Stop flag
Output completion
auto-reset
Enabling fixed slope
ramp-up/down
Executing an interrupt
program when pulse
output ends
The output
immediately stops
when the instruction is
disabled or stops
Present output
position
Start/end
frequency(Hz）
Ramp-up time（ms）
SR476 SR496
SR477 SR497
Attribute StopRun
R OFF
R / W OFF
R / W OFF
R / W OFF
R / W OFF
R / W OFF
R / W OFF
R / Wd No change
R / Wd No change
R / Wd No change
Cha p ter 6 App l ied Ins truc tio ns
SR516 SR536
SR517 SR537
RunStop Power ON
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
No change No change
No change No change
No change No change
SR556 SR576
SR557 SR577
Factory
Latched
default
OFF N
OFF N
OFF N
N
OFF
N
OFF
N
OFF
N
OFF
0 Y
Y
200
200 Y
6 - 9 0 9
6_