Removing And Installing The Bracket Without The Master Cylinder (Rapid 2011 ►) - Skoda Fabia II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
Note
Position self-locking nuts -1- and -2- for bracket -3- on front wall.
– The support -A- must be located on the actuating rod -B- of
the master cylinder.
– To click in the support -A-, press the clutch pedal towards the
front wall in -direction of arrow-. While doing so, make sure it
catches correctly in the support.
– Install the clutch pedal switch - F36-
– If present, install the crash strut
– Install the footwell vent ⇒ Heating and Air Conditioning; Rep.
gr. 87 .
1.12 Removing and installing the bracket
without the master cylinder (Rapid 2011
►)
Special tools and workshop equipment required
♦ Pliers - T10005-
Removing
– Removing the footwell vent ⇒ Heating and Air Conditioning;
Rep. gr. 87 .
– Put steering wheel in the highest position.
– Unplug connector from the clutch pedal switch - F36- .
– Unscrew the top fixing nut -arrow- for the bracket. To do so,
position an long extension on the nut in the opening between
the dash panel -2- and the bottom steering column trim panel
-3-.
44
⇒ page 31 .
⇒ page 32 .