Skoda Fabia II 2007 Workshop Manual page 35

Removing and installing tension spring
– Removing and installing with hook - 3438- .
– Insert the vibration damper with the recess -arrows- as of the
2nd spring coil -arrows-.
1.7.1 Removing and installing clutch pedal
switch - F36-
Note
The clutch pedal switch - F36- may only be installed once to en‐
sure that it has an adequately tight fit in the bracket.
Removing
– Removing the footwell vent ⇒ Heating and Air Conditioning;
Rep. gr. 80 .
Note
The clutch pedal switch is installed from the front wall.
– Unplug connector from the clutch pedal switch - F36- .
– Turn the clutch pedal switch at the bracket 45° in
-direction of arrow- and remove it from the support.
Install
• The tappet -A- of the clutch pedal switch must not be pulled
out.
• Grease the tappet head -arrow-.
• Assign the grease via the ⇒ Electronic Catalogue of Original
Parts .
• When installing the clutch pedal switch the clutch pedal must
always remain in the off position. During the complete assem‐
bly, the clutch pedal must only be touched with the tappet head
-arrow- of the clutch pedal switch .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
31