Skoda Fabia II 2007 Workshop Manual page 75

Complaint
Clutch pedal does not return to ini‐
tial position.
Complaint
Actuating force on the clutch pedal
too high.
Complaint
Noises when operating the clutch. ♦ Release bearing defective,
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Fault description
♦ Air in line system.
♦ Line system, master or slave
cylinder leaking.
♦ Release bearing is tilted on the
guide bushing, seizured.
♦ Membrane spring of the pres‐
sure plate broken.
Fault description
♦ Over-centre helper spring de‐
fective.
♦ The clutch release force has in‐
creased through the wear of the
clutch lining.
♦ Release bearing is tilted on the
guide bushing, seizured.
♦ Pressure plate with wrong
spring identification.
♦ Mechanical fault at the pressure
plate or the clutch disc.
♦ Clutch disc on the serration
sluggish/jams.
Fault description
guide of clutch release bearing
not in order, contact surface
drained off.
♦ Contact surface of the pressure
plate defective (tips of mem‐
brane spring bent, broken). Re‐
lease bearing is off-center.
Gearbox 02T - Edition 05.2014
Measure
– Vent air from the line system;
top up with brake fluid.
– Replace defective component,
vent air from the line system; top
up with brake fluid.
– Replace guide bushing and re‐
lease bearing.
– Replace pressure plate.
Measure
– Replace over-centre helper
spring.
– Inform customer (higher release
force with increased wear).
– Replace the clutch disc if the
distance base of the rivet is be‐
low 0.1 mm.
– Replace defective components.
– Assign pressure plate via the ⇒
Electronic catalogue of original
parts .
– Replace defective components.
– Check the hub for damage
(burrs), if necessary replace
clutch disc.
– Clean the hub and the drive
shaft serration from corrosion
and residues of lubricant and
grease with grease for plug ser‐
ration of clutch disc -
G 000 100- . Move clutch disc
back and forth, remove excess
grease.
Measure
– Always replace noisy release
bearing.
– Replace damaged guide bush‐
ing.
– Replace pressure plate.
– Check release bearing and
guide bushing, replace if neces‐
sary.
– Check position of clutch release
lever.
– Check dowel sleeves.
3. Repairing clutch
71