Skoda Fabia II 2007 Workshop Manual page 151

Pull out the cylindrical-roller bearing from the clutch housing
– When removing compress circlip of the cylindrical-roller bear‐
ing -arrow- with pliers -C-.
A - Countersupport , e.g. -Kukko 22/1-
B - Interior extractor 30...37 mm , e.g. -Kukko 21/5-
Press the cylindrical-roller bearing into the clutch housing
– Support the clutch housing by positioning pipe section -
MP3-450 (VW 415 A)- (not visible in figure) directly under the
bearing support.
– When pressing in, the cylindrical-roller bearing compress the
circlip -arrow- with pliers -A-.
– Remove pliers before the cylindrical-roller bearing is in fitting
position. The circlip must lock into the clutch housing slot.
Press the circlip -1- out of the slot
A - Protective glove
WARNING
Prevent uncontrolled ejection of the circlip.
Press off the sliding sleeve and the synchronizer body for the 1st
and 2nd gear from the drive shaft
– After removing the circlip, at the same time press off the drive
shaft from the synchronizer body as well as from the 2nd gear
sliding gear.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
2. Output shaft
147