Skoda Fabia II 2007 Workshop Manual page 161

Remove outer ring/tapered-roller bearing from gearbox housing
A - Countersupport , e.g. -Kukko 22/2-
B - Interior extractor 46 up to 58 mm , e.g. -Kukko 21/7-
Press in outer ring/tapered-roller bearing in the gearbox housing
– If necessary, position adjusting washer S 1 always 1 mm thick,
under outer ring.
Note
On gearboxes made out of aluminium as of production date 12.06
the adjusting washer S 1 for outer ring/tapered-roller bearing is not
fitted The bearing pedestal for outer ring/tapered-roller bearing in
the gearbox housing is adapted. Difference between the housings
⇒ page 160 .
– Support the gearbox housing with pipe - MP6-419 (3259)- and
pressure pipe - MP6-408 (30-14)- directly below the bearing
support.
Remove inner ring/tapered-roller bearing on the side of the dif‐
ferential cage
– Before fitting the extractor, position distance sleeve -
MP3-458/2- and thrust piece - MP3-431 (3002)- on the differ‐
ential gear housing.
Press on inner ring/tapered-roller bearing on the side of the dif‐
ferential cage
WARNING
Wear protective gloves!
– Before pressing on, heat the inner ring/tapered-roller bearing
with the hot-air blower - V.A.G 1416- to approx. 100°C.
– Support the opposite side of the inner ring with an insertion
bushing - MP3-412 (VW 455)- .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
2. Differential gear
157