Skoda Fabia II 2007 Workshop Manual page 147

Remove supporting ring
– Unclip the hook -A- of the supporting ring from the synchron‐
izer body with a screwdriver.
Disassembling and assembling the sliding sleeve/5th gear syn‐
chronizer body
1 - Spring (as of production date 06.09 the springs are longer) ⇒
Electronic Catalogue of Original Parts
2 - Arresters for synchronizer body
3 - Synchronizer body; fitting position: The groove on the front
side -arrow A- and the wide collar -arrow B- point towards the 5th
gear.
4 - Sliding sleeve
5 - Supporting ring
– Slide the sliding sleeve over the synchronizer body.
The deeper recesses -arrow C- of the arresters in the syn‐
chronizer body and the recesses -arrow D- in the sliding sleeve
must be positioned above one another.
– Insert the arresters in the deeper recesses and mount the
springs by turning them 120°.
The angled end of the springs must grip into the hollow arrester
of the synchronizer body.
Install supporting ring
– Place the supporting ring onto the flywheel type belt pulley fit‐
ting tool -MP9-400- .
– Insert the supporting ring together with the fitting tool in the
synchronizer body/5th gear sliding sleeve (Observe fitting po‐
sition ⇒ page 143 ). Lock the hooks -arrow 1- in the recesses
-arrow 2- of the synchronizer body arresters.
– Push the supporting ring down until the hooks click into posi‐
tion.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
1. Drive shaft
143