Skoda Fabia II 2007 Workshop Manual page 63

Unlock the actuating rod/master cylinder from the clutch pedal as
follows:
– Insert pliers - T10005- in the clutch pedal recesses.
– Press together support and separate the clutch pedal from the
master cylinder.
– Removing the over-centre helper spring
– Unscrew the nuts -arrows 1- and remove the clutch controls
-arrow A- together with the master cylinder.
– Unscrew pedal stop
– Remove the master cylinder.
1.19.2 Install
Installation is performed in the reverse order, pay attention to the
following points:
– The support -A- must be located on the actuating rod -B- of
the master cylinder.
– To click in the support push the clutch pedal towards the front
wall in the -direction of the arrow-; while doing so make sure
it catches correctly.
– After installing the master cylinder bleed the clutch control
⇒ page 65 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
⇒ page 24
⇒ page 19 ,-Pos. 19-.
Gearbox 02T - Edition 05.2014
.
59