Skoda Fabia II 2007 Workshop Manual page 66

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
Note
If the slave cylinder must be replaced due to a predetermined
♦
fault, first of all check the hydraulic clutch control
If the slave cylinder with the connected tube-hose line is re‐
♦
moved from the gearbox, do no longer depress the clutch
pedal. Otherwise, the piston can be pressed out of the slave
cylinder and thus be destroyed.
When performing the following work, make sure no brake fluid
♦
comes into contact with the gearbox. If this is the case, these
points must be cleaned thoroughly.
1.21.1 Removing
Note
If the battery earth strap is disconnected and connected, carry out
additional operations ⇒ Electrical System; Rep. gr. 27 .
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– If present, remove engine cover ⇒ Engine; Rep. gr. 10 .
– Remove air filter ⇒ Engine; Rep. gr. 23 or ⇒ Engine; Rep.
gr. 24 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
– Remove circlip -arrow 1- for shift cable from gearbox shift lever
-A-.
Vehicles Fabia II and Roomster up to 05.07 and vehicles Rapid
(metal relay lever)
– Remove circlip -arrow 2- for selector cable from relay lever
-B-.
– Remove selector cable and shift cable from the studs.
– Detach circlip -arrow 3- from the relay lever -B- and remove
relay lever.
Vehicles Fabia II and Roomster as of 06.07 and vehicle Rapid NH
(plastic relay lever)
– Pull off shift cable from the stud.
– Remove relay lever together with cable lock
Continued for all vehicles
– Remove the gearshift lever -A-, for this step unscrew nut
-arrow 4-.
62
⇒ page 57 .
⇒ page 87 .