Skoda Fabia II 2007 Workshop Manual page 145

Press on the synchronizer body with the 3rd and 4th gear sliding
sleeve
Press on the inner ring -A- for the cylindrical-roller bearing
– Insert the circlip.
Determining the circlip thickness
– Insert circlip with a thickness of 2.0 mm in the slot of the drive
shaft and push upwards.
– Measure the dimension between the inner ring of the taper
roller bearing and the positioned circlip using a feeler gauge.
– Remove the circlip used to take the measurement.
– Determine thickness of circlip according to the table.
Note
Assign the circlips via the ⇒ Electronic catalogue of original parts .
The following circlips are available:
Measured value
(mm)
0.05...0.14
0.15...0.24
0.25...0.34
0.35...0.44
0.45...0.51
Press the bearing support for grooved ball bearings onto the input
and output shafts
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Circlip thickness Axial play (mm)
(mm)
2.0
2.1
2.2
2.3
2.4
Gearbox 02T - Edition 05.2014
0.05...0.15
0.05...0.15
0.05...0.15
0.05...0.15
0.05...0.10
141
1. Drive shaft