Skoda Fabia II 2007 Workshop Manual page 71

8 - Gearbox
9 - 20 Nm
10 - Support
11 - Slave cylinder
❑ removing and installing
❑ Grease tappet head with grease - G 000 100-
Remove and install the clutch release lever together with the re‐
lease bearing and guide bushing
– Release screws -arrows-.
– Separate the clutch release lever together with the release
bearing and guide sleeve from the drive shaft and ball stud.
Installation is carried out in the reverse order.
Removing and installing the guide sleeve
– Rotate the guide bushing -3- opposite the release bearing
-2- by approx. 90° in the -direction of the arrow- until the catch
pegs of the guide bushing are aligned with the slots -4- of the
release bearing.
– In this position remove the guide sleeve from the release bear‐
ing.
Installation is carried out in the reverse order.
Removing and installing the release bearing
– Press the catch pegs -arrows- together and remove clutch re‐
lease bearing -A- from the clutch release lever.
– To install press clutch release bearing -A- into the clutch re‐
lease lever until the catch pegs -arrows- lock into position.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
⇒ page 61
Gearbox 02T - Edition 05.2014
2. Repairing the clutch release mechanism
67