Setting The Shift Mechanism - Skoda Fabia II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
– Apply a small quantity of grease - G 000 450 02- onto the studs
-arrows- of the gearbox shift lever -1- and of the relay lever
-2-.
– Always replace lock washers -3- and -4- after each disassem‐
bly ⇒ Electronic Catalogue of Original Parts .
– Secure the shift cable with the lock washer -3- and the selector
cable (for metal relay lever) with the lock washer -4-.
– Align shift housing parallel to vehicle body.
• The distance to the vehicle body must be the same on both
sides.
– Assemble exhaust system free of stress and attach tunnel
bridges ⇒ Engine; Rep. gr. 26 .
– If present, position the noise insulation on the shift housing.
– Install centre console ⇒ Body Work; Rep. gr. 68 .

– Setting the shift mechanism

– Install air filter ⇒ Engine; Rep. gr. 23 or ⇒ Engine; Rep. gr.
24 .
– Install the battery tray and battery ⇒ Electrical System; Rep.
gr. 27 .
Note
After the battery earth strap is disconnected and connected, carry
out additional operations ⇒ Electrical System; Rep. gr. 27 .
Tightening torques
Components
Underbody cover
Shift housing to body
Cable support to gearbox
Tunnel bridge
Bracket for pre-exhaust pipe
1.12 Setting the shift mechanism
Special tools and workshop equipment required
♦ Rig pin - T10027A-
♦ Disassembly wedge - 3409- (2 pieces - Fabia II, Roomster)
♦ Release tool - T30098- (2 pieces - Rapid, 1 piece - Rapid NH)
Note
The following are required for correct setting of the shift mecha‐
nism:
• Gearbox, clutch and clutch control in perfect condition.
• Selector mechanism must move freely.
• Control elements and transmission elements of the shift mech‐
anism are in perfect condition.
96
⇒ page 96 .
Tightening torque
2 Nm
⇒ page 82
⇒ page 84
⇒ Engine; Rep. gr. 26
⇒ Engine; Rep. gr. 26