Skoda Fabia II 2007 Workshop Manual page 143

Press out the bearing support for grooved ball bearing
– Move the sliding sleeve for 1st and 2nd gear to 2nd gear.
– Slide the pressure plate - T10084A- sideways up to stop onto
the drive shaft.
– Insert centering pins in pressure plate - T10081- in the holes
of the drive shaft and output shaft.
Note
Always replace bearing support for grooved ball bearing.
Remove the bushingof the cylindrical-roller bearing with the 4th
gear sliding gear
– Removing the circlip.
– Insert separating device -A- behind the running gearing (not
the engaging gearing) of the 4th gear and press off.
A - Separating device 12 to 75 mm , e.g. -Kukko 17/1-
Install the bushing of the cylindrical-roller bearing/4th gear sliding
gear
– Partly pressing on bushing -A-.
– Position cylindrical-roller bearing -Pos. 17- and 4th gear slid‐
ing gear.
– Press down sleeve -A- with thrust washer -Pos. 18- and inner
ring/cylindrical-roller bearing -Pos. 19-.
Press off sliding sleeve and synchronizer body for the 3rd and 4th
gear
– After removing the circlip jointly press off the 3rd gear sliding
gear and the sliding sleeve/synchronizer body.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
1. Drive shaft
139