Skoda Fabia II 2007 Workshop Manual page 125

– Remove transmission neutral sender - G701- -arrow-.
Continued for all gearboxes
– Remove the gearshift shaft with cover -A-; to do this, put the
gearshift shaft in idle position. Subsequently unscrew screws
-arrows- and remove the gearshift shaft from the gearbox
housing.
– Remove the bearing pins -B- at the top of the gearbox.
– Unscrew the reversing lights switch - F4- -C-.
– Unscrew screw -A- for reverse shaft support.
– Remove the bearing pins -B- at the bottom of the gearbox.
Note
Do not remove the cover -arrow- to disassemble the gearbox.
– Press off the drive shaft and output shaft together with the
bearing support, shift forks and reverse gear.
Note
Position the gearbox housing on the pressure plates -
♦
MP3-406 (VW 401)- and -MP3-407 (VW 402)- in such a way
that the dowel sleeves in the gearbox housing are not dam‐
aged.
During the pressing off procedure request the assistance of
♦
second mechanic to prevent components from falling.
♦ Always replace bearing support for grooved ball bearing after
removing ⇒ Electronic Catalogue of Original Parts
– Pressing off the drive and output shaft from the bearing sup‐
port for grooved ball bearings
4.6.2 Install
– Pressing the drive and output shaft into the new bearing sup‐
port for grooved ball bearings
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
⇒ page 135 .
⇒ page 135 .
Gearbox 02T - Edition 05.2014
4. Disassembling and assembling the gearbox
121