Skoda Fabia II 2007 Workshop Manual page 21

♦ These are not interchangeable. If re-using, allocate synchron‐
izer rings to the same sliding gear.
♦ Inspect for wear, replace if necessary ⇒ Electronic Catalogue
of Original Parts .
♦ Check grooves -arrow 1- on synchronizer ring -A-, or check
the inside of the ring for flattened parts (grooves worn).
♦ When installing the intermediate ring -B-, check outer contact
surface -arrow 2- and inner contact surface -arrow 3- for
grooves, blue coloring (caused by overheating) and other
damages.
♦ Insert moist with some gearbox fluid.
Pinions
♦ Clean and heat on a heating plate or with the hot-air blower ,
e.g. -V.A.G 1416- to approx. 100°C before pressing on.
♦ The temperature can be checked with a temperature measur‐
ing instrument.
♦ Check fitting position.
Clutch control
♦ When removing gearbox, remove slave cylinder, do not de‐
tach the hoses.
♦ If the slave cylinder with connected hydraulic line is removed,
do not depress the clutch pedal. Otherwise the tappet is press‐
ed out of the slave cylinder.
♦ Do not tilt the clutch pressure plate; release and tighten cross‐
wise in small stages.
♦ If the clutch pedal does not return to its initial position after the
coupling procedure - clutch pedal in home position - the clutch
control must be bled
⇒ page 57 ).
♦ In order to reduce unpleasant odours if the clutch is burnt,
thoroughly clean the clutch housing as well as the flywheel and
the engine on the side of the gearbox.
Safety precautions for vehicles with start-stop system
WARNING
On vehicles with start-stop system, there is the risk of injury
from automatic engine start.
♦ On vehicles with activated start-stop system (recogniza‐
ble by a message in the dash panel insert), the engine can
start automatically if required.
♦ It is therefore necessary to ensure that the start-stop sys‐
tem is deactivated when carrying out work on the vehicle
(ignition switched off; if required switch ignition on again).
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
⇒ page 65 (further measures
Gearbox 02T - Edition 05.2014
3. General repair instructions
17