Skoda Fabia II 2007 Workshop Manual page 142

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
❑ removing ⇒ page 138
❑ pressing on ⇒ page 138
❑ Fitting position: The circlip in the bearing points towards the drive shaft
22 - Clutch housing
❑ repairing ⇒ page 126
23 - Spring
❑ on gearboxes as of production date 06.09, the springs of the sliding sleeve with synchronizer body for
3rd, 4th and 5th gear are changed (the springs are longer)
❑ Fitting position ⇒ page 140
24 - Sliding sleeve 3rd and 4th gear
25 - Synchronizer body for 3rd and 4th gear
26 - Arresters for synchronizer body
❑ (3 pieces)
27 - Spring
❑ on gearboxes as of production date 06.09, the springs of the sliding sleeve with synchronizer body for
3rd, 4th and 5th gear are changed (the springs are longer)
❑ Fitting position ⇒ page 140
28 - Arresters for synchronizer body
❑ (3 pieces)
29 - 5th gear synchronizer body
30 - 5th gear sliding sleeve
31 - Supporting ring
❑ prevents the arresters from wandering
❑ removing ⇒ page 143
❑ installing ⇒ page 143
Pull out the cylindrical-roller bearing from the clutch housing
– When removing compress circlip -arrow- of the cylindrical-roll‐
er bearing with pliers -C-.
A - Countersupport , e.g. -Kukko 22/1-
B - Interior extractor 30 up to 37 mm , e.g. -Kukko 21/5-
Press the cylindrical-roller bearing into the clutch housing
– Support the clutch housing by positioning pipe section -
MP3-450 (VW 415 A)- (not visible in figure) directly under the
bearing support.
– When inserting compress circlip -arrow- of the cylindrical-roller
bearing with pliers -A-.
– Remove pliers before the cylindrical-roller bearing is in fitting
position. The circlip must lock into the clutch housing slot.
138
Rep. gr.35 - Gears, shafts