The Trap Destination Screen - ZyXEL Communications GS1900-8 User Manual

Figure 200 Configuration > Management > SNMP > Trap
The following table describes the labels in this screen.
Table 166 Configuration > Management > SNMP > Trap
LABEL
SNMP Trap
SNMP Authfailure
Trap State
SNMP LinkupDown
Trap State
SNMP Warm-Start
Trap State
SNMP Cold-Start
Trap State
Apply
Cancel

31.3.9 The Trap Destination Screen

Use this screen to view the Trap Destination settings. Click Configuration > Management >
SNMP > Trap Destination to open this screen.
Figure 201 Configuration > Management > SNMP > Trap Destination
Chapter 31 Configuration: Management
DESCRIPTION
Select the SNMP entity is permitted to generate authentication failure traps. Possible
modes are:
• Enabled: Enable SNMP trap authentication failure.
• Disabled: Disable SNMP trap authentication failure.
Select the SNMP trap link-up and link-down mode operation. Possible modes are:
• Enabled: Enable SNMP trap link-up and link-down mode operation.
• Disabled: Disable SNMP trap link-up and link-down mode operation.
Reboot using software or hardware button reboot.
Reboot though power off.
Click Apply to save the changes.
Click Cancel to discard the changes.
GS1900 Series User's Guide
205