Trap Community Command; Trap Destination Set Command; Show Snmp Settings Command; Server Show Command - ZyXEL Communications AAM1212 User Manual

AAM1212 User's Guide

26.2.4.4 Trap Community Command

Syntax:
sys snmp trapcommunity <community>
where
<community>
Enter this command with the community to set the password.

26.2.4.5 Trap Destination Set Command

Syntax:
sys snmp trapdst set <ip> [<port>]
where
<ip>
[<port>]
Use this command specify the IP address (and port number) of the trap server to which the
AAM sends SNMP traps. If you leave the trap destination set to 0.0.0.0 (default), the AAM
will not send any SNMP traps.

26.2.4.6 Show SNMP Settings Command

Syntax:
sys snmp show
This command displays the current SNMP get community, set community, trap community,
trusted hosts and trap destination settings.

26.2.5 Server Show Command

Syntax:
ras> sys server show
This command displays which services may be used to access the AAM.
An example is shown next.
186
= The password sent with each trap to the SNMP manager.
= The IP address of the trap server.
= The port number upon which the trap server listens for SNMP traps.
The AAM uses the default of 162 if you do not specify a trap port
Chapter 26 Sys Commands