C
Appendix
Configuring the Management Module
The management module (HMM) needs to be configured only once, when first
installed. However, as the Fibre Channel grows, it might be desirable to
change parameters and settings. In addition, new releases of the HMM's
firmware will need to be installed as they become available. All these actions
require interaction with the firmware. In this appendix we cover the most
common firmware parameters, particularly those needed for the initial set up
of the HMM. Downloading new firmware is covered in Appendix B,
"Updating the Firmware."
A connection to the HMM must be established before proceeding with module
configuration. If this has not taken place, see Compaq Storage Hub 12
Management Module installation instructions, included with your user
documentation.
The first step is to reset the hub. This can be done by either powering up the
hub or pressing the reset button. The Compaq Storage Hub 12 hub will run
several self-tests as shown in the figure below.
Figure C-1. Hub Self-Tests