Show Port Properties; Verify Port Status; Check Firmware Versions - Compaq Armada 6500 Hardware And Software Manual

3-10 Compaq Storage Hub 12 Management Utilities Hardware and Software User Guide

Show Port Properties

Verify Port Status

Check Firmware Versions

From the Ports tab:
1. Click the Bypass Control check box by the appropriate port number to
check or uncheck the Bypass control box. This box toggles between Set
and Cancel for this field.
2. Click OK or Cancel at the message.
From the physical device panel Port Context Menu:
1. Right click over the port of choice in the Device View. The Port
Context Menu will display.
2. Click Force bypass port, or Enable port to set or cancel this option.
3. Click OK or Cancel at the informational message.
The Status field can change to represent the state of the port following the
setting or canceling of port bypass control. If the port is enabled, that port has
a properly operating Fibre Channel device connected to it and the port has not
had its force bypass control set. If the port is bypassed, the port has had its
Force Bypass control set, or else no properly operating Fibre Channel device
has been connected to the port (as determined by the device).
To view all of the port information from the Expanded Device View, click on
the Ports tab. Alternately, in Device View, right click over any port and select
Port Details.
To verify a port's status, from Expanded Device View:
1. Click the Ports tab.
2. Verify the status for the port number in question.
From Expanded Device View, click the Service tab. In this view, firmware
revisions of the agent and the device controller can be checked.