Compaq Armada 6500 Hardware And Software Manual page 74

4-10 Compaq Storage Hub 12 Management Utilities Hardware and Software User Guide
Table 4-1
Error Messages
Message
Power supply fault for hub.
Right-click item in the first
column.
SNMP++:SNMP request timed
out.
Temperature fault indicated
for hub.
Terminating management
requests.
continued
Description
Check for the source of the
problem. Is there a general
power failure at the site? Are
there rolling brownouts at your
site? Is a solid connection being
made between the hub and
power supply? Is the power
cable faulty?
Windows supports selection
from any row, but only within
column one.
This message displays when a
device is connected and HMU is
polling but no SNMP response is
received.
Check for the source of the
problem. Is there an obstruction
blocking the cooling fans?
Remove it. Is the temperature
setting in range? Adjust the set-
ting and click OK. Watch for
improvement.
This message is informational
when exiting from HMU.
Action
If none of the answers to the
above questions are
responsible, call Customer
Service. Do not attempt to open
the power supply in the device.
Click OK and right click in
column one.
Check the Ethernet connection,
verify the IP address, and ping
the node for a response.
Shut down HMU and then restart
HMU.
If polling requests still go
unanswered, reset the device's
firmware with the Reset button
on the panel with the LED
indicator.
If neither of these improves the
situation, call Customer Service.
No action is required.
continued