Using Call Group - Muratec MFX-2530 Operating Instructions Manual

Phoning via speed-dial
To make a phone call using a speed-dial number, you must have an optional handset
attached to your machine. To make the call:
1
Obtain a dial tone by doing one of the following:
• Lift the handset
• Press / to use the monitor speaker
MONITOR CALL
2
Press / .
SPEED DIAL TEL INDEX
3
Use the numeric keypad to enter the three-digit identifier for the speed-dial
number you want to dial.
Note: Remember that your fax machine's monitor speaker is not a speakerphone.
If you dialed using the monitor speaker, pick up the handset to speak to the
person that answers.
Note: If the call fails, and you used
MONITOR
hang up.
/ to dial, press / to
CALL MONITOR CALL

Using call group

If you frequently send the same fax message to more than one location, store the
group number into your autodialer. (If necessary, see "Using a one-touch dial" and
"Using speed-dialing", in previous pages.)
After you store the group number, you can send the same fax to many different loca-
tions. For example, one call group may include all of your clients in one city, another
group may include all of your employees and another may include all your vendors.
Your machine can:
• Store as many as 300 numbers in up to 32 call groups
• Store one number in as many as 32 different groups
Send a fax via call group
Note: The group number dialing can be used only for memory transmission.
1
Place the document and the select resolution and contrast you desire.
2
Press [Group].
3
Use the numeric keypad to enter the group
number you want to use to send a fax.
Note: If you want to send a fax to several
groups at a time, press [Broadcas]
then repeat steps 2-3. You can also enter the other locations using
either a one-touch key, speed-dial number or numeric keypad.
4
Press .
START
Advanced fax
Transmission
Press START.
_
G01
Group Clear Broadcas
3.21