Tti Select; Automatic Document Size Detection; Select Scanning Size To Be Sent - Muratec MFX-2530 Operating Instructions Manual

Basic fax

TTI select

When you send a fax message, your TTI is automatically printed at the top of docu-
ments you send. You can select one of three TTI you've stored in your machine.
Note: See "EasyStart" on pages 1.17–1.18, to refer the storing the TTI.
To select the TTI:
1
Place the document and select resolution and contrast you require.
2
Press until [TTI] is appeared on the
NEXT
3
Press [TTI].
4
Using a cursor key to select TTI you want to
send.
5
Press [Enter].
6
Dial a fax number.
7
Press .
START
Note: After transmission if you did not select TTI before sending a document, the
stored TTI you've selected in EasyStart will be printed at the top of docu-
ment you send.

Automatic document size detection

Your machine can automatically detect the following size of your document.
• Letter (8.5 11 )
• Legal (8.5 14 )
• Ledger (11 17 )
• Half-letter (5.5 8.5 )
Note: Half-letter is available only with the
If you set the non-standard sized document or the machine could not detect the doc-
ument size, select the scanning size manually. (See the right column.)
3.2
TTI
Use cursor to select
.
TTI.
LCD
1:AABBCC
2:BBCCDD
3:CCDDEE
Enter
.
FBS

Select scanning size to be sent

When you send or store your document, usually the machine automatically detects
the size of your document when it is placed on the
wish to override this and select scanning size manually, proceed to the following
steps.
Note: You can select one of the following standard paper sizes.
•Letter(8.5 11 )
•Half-letter(5.5 8.5 )
•Legal(8.5 14 )
•Ledger(11 17 )
* : Half-letter is available only with the
Note: If you want to set the different sized documents at a time in
Mix Length feature on. (See page 3.33.)
Note: To override auto document size detection, you have to set the scanning size
at each page scanning.
To select the scanning size manually:
1
Place the document and select resolution and contrast you require.
2
Enter , [ScanSize].
NEXT
3
Select desired size by using a cursor key.
Note: When you use the
ADF
shaded and cannot be selected.
4
Press [Enter].
5
Enter the fax number and press
or glass. However, if you
ADF FBS
*
.
FBS
ADF
Scan Size
Use cursor to select
scanning width.
, "H.LTR" will be Auto H.LTR
11x17 Letter
Legal
H.LTR
Letter
.
START
, turn the
Enter