Troubleshooting - Muratec MFX-2530 Operating Instructions Manual

Troubleshooting

Occasionally, your machine encounters some trouble transmitting or receiving docu-
ments. When it does, it alerts you with an alarm. You can identify the problem with
messages and printed check messages and error reports, explained in the follow-
LCD
ing pages.
Alarm
Your fax machine sounds an alarm tone — a series of short beeps — if either of
these two problems occur:
• Trouble transmitting or receiving
• The machine is out of paper
error messages
LCD
If a message not listed here is displayed, take corrective action by following the
instructions in the message.
< Copy >
What you see on the What it means/What to do
LCD
ADF is not When use the series copy function, the document is set in
available. the . You cannot use the
ADF
Set document Remove the document from
on FBS glass on glass.
FBS
Auto doc. size Non-standard size document is set. Your machine can
detection failed. detect Letter
11 17 (ledger
Pressing
START
paper. Or, press
the [Paper]. And then try again.
. . . or . . .
Document is not set. Set your document.
Check paper size The paper size setting is incorrect.
Check the paper size and set the proper paper size.
for series copy.
ADF
, then set the document
ADF
, Legal , Half-letter and
) sized document only.
to copy your document to the auto selected
then select paper manually by using
STOP
Copy protected You tried to use your machine to make a copy, but the
unit's copy protection feature is on, preventing such use.
Turn off copy protection. (See "Copy protect" on page 4.7)
Enter job hold time. You tried to use the "Last Job" feature, but the "Last Job
hold time" has not been entered. Enter the "Last Job hold
time". (See "Last Job Hold Time" on page 2.28.)
No paper size Your machine does not have suitable sized papers for Mix
is suitable. length copy. To continue, press
OK to continue papers the
LCD
copying? other ratio.
No paper size There is no paper that matches the reduce/enlarge ratio.
is suitable. Press then select paper manually.
STOP
Copying with auto
selected paper.
Not enough memory The copying was stopped because of memory overflow.
The last XXX page Please copy again from indicated page.
was erased.
Please copy again.
Not available with You have set two functions that conflict with each other.
XXXX Cancel either one of the two functions.
Please call service The printer unit of your fax machine has become inopera-
ble. Call your authorized Muratec dealer or Muratec
Customer Support.
Not enough memory. The "Last Job" document cannot be stored due to a
Document was erased. memory shortage.
Rotate document In combine, repeat, series copy or booklet
by 90° or set ratio function, the document is set in the incorrect direction.
Set the document in the rotate by 90° or set the
reduce/enlarge ratio.
Set document in ADF In Booklet copy, you cannot use the
Set your document in
Unable to set You cannot set the reduce/enlarge ratio during
ratio during the directional magnification function is used.
D.Mag. is used.
Just in case
and supply the
START
shows. Or, press and select
STOP
glass.
FBS
for Booklet copies.
ADF
5.11