Easystart (Initial Setting); Clearing Stored Settings; Language Settings; Getting Started - Muratec MFX-2530 Operating Instructions Manual

EasyStart (Initial setting)

EasyStart software is already installed on your Muratec machine. It guides you
through the process of entering your machine's settings.
Remember that the settings you make here can always be changed later.

Clearing stored settings

Before using EasyStart, clear your machine's built-in user data memory. This
ensures the memory will hold only your settings.
Important: After you use EasyStart, do not clear the memory again unless an
authorized technician asks you to do so.
To clear the machine's memory:
1
Press , *, 2. The now asks if you want
MENU LCD
to clear the memory.
Note: If you don't want to clear the memory,
just press [Cancel].
2
If you do want to clear the memory, press
[Enter].

Language settings

English is the language your machine initially displays on the
reports. But you can set it to "speak" French or Spanish, too.
As you give the order for the machine to change languages, it "rolls" from English to
French to Spanish, and then back to English.
To make the change from one language to the next, press

Getting started

Determine the following before you go any further:

Entering initial settings

User data clear
Check
Important: If you press
Cancel Enter
and uses to print
LCD
, #.
MENU
1
The type of dialing your telephone system requires — Choose either tone or
pulse (rotary) dialing.
2
The name and fax number you want to appear on your faxes —
Every fax page you send arrives at the receiving machine with a single line of
text at the very top of the page. This text lists a name and a fax number,
which are called a Transmit Terminal Identifier (
than 22 characters.
during EasyStart, your machine returns to standby
RESET
mode (its normal condition). But it will keep the settings you saved by
pressing [Enter] as described in these instructions.
1
Press to change to Fax mode, if the machine is in Copy mode.
FAX
2
Press , [Fax Set], , [Enter].
MENU I
The shows the current calendar/clock setting, with a cursor appearing
LCD
under the first digit.
3
Use the numeric keypad to enter the correct
date and time, using a 24-hour format for the
time. For instance, to set 1:30 on November
PM
26, 2001, press 2 0 0 1 1 1 2 6 1 3 3 0.
Note: Your machine automatically inserts the
spaces and date-slash. All you have to
do is enter the digits.
To change a digit, press the cursor key to move the cursor. Then enter the cor-
rect digit.
Getting started
). The cannot be longer
TTI TTI
I.User Install
Enter current time.
2001 11/26 13:30
Enter
1.17