Muratec MFX-2530 Operating Instructions Manual page 177

Invalid protect passcode The protection passcode you entered isn't valid.
Repeat the operation, entering the correct protec-
tion passcode.
No command stored You pressed
upcoming commands, but your fax machine had
none stored.
No document stored You tried to print a document from memory, but
your fax machine had none stored.
No protect passcode You tried to protect an operation or department
code but there's no protection passcode stored in
your fax machine. Store a protection passcode in
your machine, then retry protecting the operation
or department code.
No report You requested an activity journal or confirma-
tion report, but your fax machine has no record
of any fax jobs having occurred.
Not stored You selected an autodialer, batch box or F-Code
box number for which there is no phone number
programmed. Either choose another number or
dial a phone number directly from the numeric
keypad.
. . . or . . .
You tried to turn on the department code setting
but there are no department codes stored in
your fax machine. Store at least one department
code, then try again.
Not store in Relay box You tried to store a document for polling in an
F-Code box which is set to be a relay box.
Select an F-Code box which is set to be a bulletin
box, then try again.
Not store in Secure box You tried to store a document for polling in an
F-Code box which is set to be a security box.
Select an F-Code box which is set to be a bulletin
box, then try again.
Would you like to enter? You pressed an empty one-touch key or speed
dial number.
Press [Yes] to tell your machine to enter it, or
press [No] to cancel entering.
to review
REVIEW COMMANDS
PIN is not stored You selected "Mode1" in the
and tried to call an autodialer number in which
no PIN has been entered, or to call using
numeric keypad without
try again.
Please set Fax/Tel Mode. You tried to set the Fax Forwarding feature to
ON when the reception mode is Tel Ready.
Set the reception mode to Fax/Tel Ready.
Set Indiv Frwd #s first You tried to set the Fax Forwarding feature to
ON when all individual setting is set to OFF.
Set the individual setting to ON.
Supply paper for fax doc. Your machine receives a fax message when it
does not have standard sized papers which can
be used for the fax reception (refer to page 3.8),
or the cassette is set to OFF for "Cassette for
Rx" (refer to page 3.8). Add standard sized
papers to the cassette, or set to ON for "Cassette
for Rx".
Unable to reduce In enlargement transmission, you cannot select
the reduction ratio.
Just in case
mask feature
PIN
. Enter a , then
PIN PIN
5.13