How To Set The Document; Acceptable Document Size; Things Not To Put In Your Fax - Muratec MFX-2530 Operating Instructions Manual

How to set the document

Acceptable document size

The acceptable dimensions as follows:
• In the Automatic Document Feeder(
ADF
Feed direction
Automatic document feeder ( ) (width length)
ADF
Maximum: 11.0 17.0
Minimum: 5.8 5.0
Flatbed scanner ( ) glass (width length)
FBS
Maximum: 11.0 17.0

Things not to put in your fax

To avoid paper jams and damage to your machine, don't insert:
• Folded, curled, torn, wrinkled or very thin pages
• Documents with staples, glue, tape, paper clips or still-wet correction fluid
• "Sticky notes" (or documents with "sticky notes" attached)
• Cardboard, newspaper or fabric
• Pages with duplicating carbon on either side
• Credit cards or any small, thick items
) • On the Flatbed Scanner( ) glass
FBS
How to set the document
Setting the documents in the Automatic Document Feeder
1
Set your document face up into the docu-
ment feeder. Your machine's
ADF
up to 50 sheets.
Note: The green arrow will appear on the
cover when the document is
ADF
set.
2
Adjust the document guide to fit your
documents.
Note: If you want to set the different sized documents at a time, turn the Mix
Length feature on. (See page 2.18 for copy, or page 3.33 for fax transmis-
sion.)
Setting the documents on the
1
Lift the platen cover fully.
2
Set your document face down
on the glass. The document
FBS
should be aligned to the rear
left corner.
3
Gently close the platen cover.
Note: If you do not lift the platen
cover fully, the document size
will not be detected automatically.
Important: When copying a bound document, such as a book, the copied image
may contain some black areas. To reduce this effect, hold down the
document to prevent its bound part from rising. However, do not
press too strongly. This may break the
Getting started
will hold
glass
FBS
glass and cause an injury.
FBS
1.19