Settings For Dialing; Changing The Dialing Pause Length; Changing Redial Settings - Muratec MFX-2530 Operating Instructions Manual

Settings for dialing

Changing the dialing pause length

Default setting: 2 sec.
The pause is set by the factory to last two seconds, but you can set it to last as long
as ten seconds if necessary. To change the pause length:
1
Press , , 0, 4, [Enter].
MENU J
2
Use the numeric keypad to enter the length you
want for the dialing pause.
Note: The length setting requires two digits.
Always enter a leading zero for lengths
less than 10 seconds.
3
Press to save the setting.
ENTER

Changing redial settings

Default setting: Number of redial: 2 times, Redial interval: 1 minute.
It's up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval).
To program the redial settings:
04.Dialing Pause
Set dialing pause. (02-10)
02 sec.
PauseTime: 2 sec. (02-10)
Enter
1
Press , , 0, 6, [Enter].
MENU J
2
Use the numeric keypad to enter the number of
redials you want. Choose from 2 to 15 redials.
Note: Enter a leading zero when entering a
quantity less than 10.
3
Press [Enter] to save the setting.
4
Use the numeric keypad to enter the length you
want between redial attempts. Choose from 1 to
5 minutes.
5
Press [Enter] to save the setting.
6
Press to return to standby mode.
RESET
Fax settings
06.Number of Redials
Set # of redials. (02-15)
02 time.
Time : 2 time.(02-15)
Interval : 1 min. (1-5)
Enter
06.Number of Redials
Set redial interval. (1-5)
1 min.
Time : 2 time (02-15)
Interval : 1 min. (1-5)
Enter
3.75