Setting Ecm - Muratec MFX-2530 Operating Instructions Manual

Adjusting the print settings
Default setting: Rx reduction rate: Normal, Reduction margin: 40 mm,
Paper saving:OFF.
1
Press , , 0, 2, [Enter].
MENU J
2
Select item you want to set using the cursor
key. Then press [Enter].
3
Select desired item and then press [Enter].
4
If you want to change other items, repeat step
2-3.
5
When you finish, press [Exit].
6
Press to return to the standby mode.
RESET
Setting the number of rings
Default setting: 2 time.
You can set how many times your fax machine will ring before answering a call.
Choose from 1 to 10 rings.
1
Press , , 0, 5, [Enter]. The
MENU J
2
Use the numeric keypad to enter the number of
rings you want, from 01 to 10.
Note: If you enter 00 (zero), the machine will
beep briefly to warn you that it can't
accept that setting.
3
Press [Enter] to save the setting.
4
Press to return to the standby mode.
RESET
02.Print Settings
Use cursor to select
item.
Rx Reduc.Rate:Normal
Reduc. Margin:40 mm
Paper Saving :OFF
Exit Enter
05.Number of Rings
Set # of rings. (01-10)
shows:
LCD
02 time.
# Of Rings : 2 time(01-10)
Enter
Setting
ECM
Default setting: ON.
"Line noise," or static on the line during a call, can easily disrupt the flow of data
from one fax machine to another.
That's why your fax machine gives you the option of using Error Correction Mode
( ). When two fax machines communicate while running in
ECM
machine automatically checks the data as it sends. If the receiving fax machine can't
verify the transmission, the first machine will re-send it as necessary.
Note: gives you a better chance of transmitting a fax document over a bad
ECM
phone line, but it could also slow down the transmission time. And the worse
the line is, the slower the transmission. That's why the machine lets you
turn on or off as needed.
ECM
Note: Not all fax machines have . If you've activated
ECM
a fax machine not currently using
transmission from a usual, non-
1
Press , , 0, 7, [Enter].
MENU J
The shows the current setting:
LCD ECM
2
Select "On" or "Off" using the cursor key.
3
Press [Enter] to save the setting.
4
Press to return to the standby mode.
RESET
Fax settings
, the sending
ECM
and then transmit to
ECM
, there will be no change in the fax
ECM
transmission.
ECM
07.ECM Mode
Use cursor to select
ON or OFF.
ON
OFF
Enter
3.73