Soft Keys - Muratec MFX-2530 Operating Instructions Manual

Soft Keys

Soft Keys are shortcut keys. You can program the soft keys on the control panel to
turn on or off any function with just the touch of a button. Your machine has four
Soft Keys. If the light above any one of these keys glows, that means the setting
programmed into that key is active.
These keys are programmed at the factory to turn the following functions on or off:
• Confirmation stamp* (see page 3.71)
• Confirmation report* (see pages 3.40–3.41)
• Monitor/Call* (see page 3.5)
• Memory transmission* (see pages 3.3 and 3.70)
But instead of using the Soft Keys to control the functions above, you can program
them to turn other functions on or off. These functions are:
• TTI Tx*— Normally, when you send the fax message, your TTI will be printed at
the top of document you send. If you programmed TTI Tx into a Soft Key, you can
disable to send your TTI by simply pressing that Soft Key.
• Cover page* (see page 3.38)
• Flash* — Lets you quickly disconnect a call and go right to the next one without
having to hang up the handset.
• Security reception (see pages 3.61–3.62)
• Auto reception (see page 3.7)
• Fax Forwarding (see pages 3.36–3.37)
• Combine (see page 2.10)
• Repeat (see page 2.11)
• Series copy (see page 2.13)
• Erase Center (see page 2.13)
• Erase Border (see page 2.14)
• TopUp Copy (see page 2.14)
• Binding Margin (see page 2.15)
• Directional Magnification (see page 2.15)
• Nega/Posi (see page 2.16)
• Last Job (see page 2.17)
• Mixed length copy (see page 2.18)
• Enhanced copy (DocEnhance) — Makes only the light areas, such as the text
written with pencil, darken selectively.
• Duplex (see page 2.19)
• Booklet (see page 2.23)
* When you change the setting by using the Soft Key, it will be available only for
the next transmission. Once that transmission is complete, your machine returns
to its default setting.
Setting the Soft Key
1
Press , [Mach Set].
MENU
2
Select "D.Soft Key" using the cursor key, and
then press [Enter].
The shows the function name currently
LCD
stored in the Soft key 1.
Note: If you want to see the all four functions
currently stored in the soft keys, press
[ShowAll]. However, when you register the other function in the Soft
Key, you should press [ShowAll] again to select the Soft Key.
3
Press desired Soft Key (1–4) on the control panel you want to change. Then
press [Enter].
Note: On the , the shaded functions are currently assigned to the Soft
LCD
keys.
1.Stamp FaxFunc.
Use cursor to select
item.
Stamp Cover Page
Report Flash
Monitor/Call
Security Rx
Memory Tx
Auto Rx
TTI Tx Fax Forward
CopyFunc Cancel Enter
Common settings
D.Soft Key
Press Soft Key
1.Stamp FaxFunc.
Exit Show All Enter
1.Stamp FaxFunc.
Use cursor to select
item.
Combine Margin
Repeat D.Mag.
Series Copy Nega/Posi
EraseBorder Last Job
EraseCenter TopUp Copy
FaxFunc. Cancel Enter
4.1