Settings For Transmission; Scan Settings; Setting Ecm - Muratec MFX-2530 Operating Instructions Manual

Settings for transmission

Scan settings

Default setting: Primary resolution: Normal, Primary contrast: Normal
Four different settings tell your machine how to scan documents. The initial factory
settings are probably right for most applications, so try using them before changing
any of these settings:
• Primary resolution mode — Sets the resolution for your documents. Choose
either normal, fine, superfine ("S-Fine" on the
• Primary contrast mode — Sets how light or dark you want faxed documents
to be when they arrive at their destination.
Note: The primary settings you choose effect your fax activity only.
To set these modes:
1
Press , , 0, 1, [Enter].
MENU J
2
To set the primary resolution mode, select
"Resol." then press [Enter].
3
Select desired resolution mode, then press
[Enter].
4
To set the primary contrast mode, select
"Contrast" then press [Enter].
5
Select desired contrast mode using a cursor key, then press [Enter].
6
Press [Exit] to exit this setting mode.
7
Press to return to the standby mode.
RESET
By following the steps above, you've set your defaults for scanning. Before sending
documents, you can "override" these default scan settings for that transmission.
To override the default resolution and contrast settings before sending a document:
• Press to change the resolution.
RESOLUTION
• Press to change the contrast.
CONTRAST
Once your document is transmitted, your machine returns to its default settings.
) or grayscale mode ("Gray").
LCD
01.Scan Settings
Use cursor to select
item.
Resol. :Normal
Contrast:Normal
Exit Enter
Setting
ECM
Default setting: ON.
"Line noise," or static on the line during a call, can easily disrupt the flow of data
from one fax machine to another.
That's why your fax machine gives you the option of using the Error Correction
Mode ( ). When two fax machines communicate while running in
ECM
ing machine automatically checks the data as it sends. If the receiving fax machine
can't verify the transmission, the first machine will re-send it as necessary.
Note: gives you a better chance of transmitting a fax document over a bad
ECM
phone line, but it could also slow down the transmission time. And the worse
the line is, the slower the transmission. That's why the machine lets you
turn on or off as needed.
ECM
Note: Not all fax machines have . If you've activated
ECM
a fax machine not currently using
transmission from a usual, non-
1
Press , , 0, 7, [Enter].
MENU J
The shows the current setting:
LCD ECM
2
Select "On" or "Off" using the cursor key.
3
Press [Enter] to save the setting.
4
Press to return to the standby mode.
RESET
Fax settings
, the send-
ECM
and then transmit to
ECM
, there will be no change in the fax
ECM
transmission.
ECM
07.ECM Mode
Use cursor to select
ON or OFF.
ON
OFF
Enter
3.69