Programming A Broadcast / Group - Muratec F-98 Operating Instructions Manual

7
There's a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of
the month. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2: Perform the command at a certain time each day you press the
key. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
Delayed
Enter Time: 00/17:05
8
Press , .
ENTER ENTER
9
The now displays the next programmable one-touch key.
LCD
If you do not want to enter or change any other key's programming, press
to return your machine to its usual standby mode.
If you do want to enter or change this key's programming, go back to step 3.
If you wish to enter or change another key's programming, go back to step 2.

Programming a broadcast / group

Note: To erase a programmable one-touch key, refer to page 2.41.
Programming a broadcast is very similar to programming a delayed transmission
except that, rather than specifying just one phone number, you set up multiple
numbers to which the transmission should go.
To program a broadcast / group into a programmable one-touch key:
1
Press , , 1, . The
PROGRAM C ENTER
Select Program No.
P1:No Number Stored
... or indicates a command is already programmed into this key.
If 1 is the key you want to program, skip to step 3. (However, our examples
P
from here will say " 4" rather than "
P
on the 30th.")
PM
today.")
PM
either shows:
LCD
1.")
P
2
Select the key in which you want to program a command or change a previ-
ously stored command and then press it. Here, we've selected
Select Program No.
P4:No Number Stored
3
If you change your mind and want to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4
Press . The
ENTER
P4:Fax Number
_
5
Use the numeric keypad to enter up to 150 fax numbers — any combination
of one-touch keys, speed-dial numbers and numbers you enter with only the
numeric keypad.
Important: Do not press
Between each number, press
Important: Do not insert a comma after the last number.
To enter a speed-dial number, press
STOP
three-digit identifier.
P4:Fax Number
A,S006,9-5552400
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance number), press
scroll leftward or
Note: If you make a mistake or want to erase characters entered in a previ-
ous setting, press
just one character in the number, press
or to move it rightward, to that character and press
erase it. Then re-enter until the number is just as you want it.
6
If you want the broadcast to begin immediately every time you press this
group key, press
If you want to delay the broadcast (perhaps to take advantage of lower phone
rates), press
COM
now shows either
LCD
P4:Fax Number
or
9-5558743_
.
ENTER
to enter a comma.
BROADCAST
/
SPEED DIAL TEL INDEX
to scroll rightward.
to erase leftward. Or, if you want to change
CANCEL
to move the cursor leftward,
and skip to step 9.
ENTER
- , .
OPTIONS ENTER
Beyond the basics
4.
P
and the number's
to
to
CANCEL
2.35