Last Copy Job - Muratec MFX-2530 Operating Instructions Manual

Last copy job

Your machine can hold the scanned data when you make a copy for a certain period.
With this feature, you can make the same copy as the previous even when you do
not have the original document.
Important: You must set the Last Job hold time in advance. (See page 2.28.)
If you want to set this feature Off, set 0 minute in the Last Job hold
time setting.
Note: The machine holds only the last copy job in the memory.
Note: This feature will be not available in the following cases:
• When the power was turned off after making a copy
• When the Last Job hold time you set has passed (see page 2.28.)
• When the scanned data was erased (see the right column)
Using Last Job feature
1
Press .
MENU
2
Select "Last Job" using the cursor key and then press [Enter].
3
Use the numeric keypad to enter the number of
copies you want.
Note: To change the number entered, over-
write it with new number.
4
Press .
START
The machine will start to make copies.
Erase the document for Last Job
The machine will erase the document for the Last Job
in the memory.
Set
Last Job 1
Enter number of copies
and press START.
002 pages
are stored in memory.
EraseDoc
1
Press .
MENU
2
Select "Last Job" using the cursor key and then press [Enter].
3
Press [EraseDoc.].
4
The will show:
LCD
Press [Yes] to erase it.
Advanced copy
Set
Last Job 1
Enter number of copies
and press START.
002 pages
are stored in memory.
EraseDoc
Last Job
OK to erase?
# of stored page :002
Yes No
2.17