Switch - Juniper EX4600 Series Hardware Manual

Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for the EX4600 Switch
* Optics, Fans and Power supply sold separately for EX4600-40F-S.
Copyright © 2014, Juniper Networks, Inc.
This topic describes the specifications for the SFP, SFP+, and QSFP+ transceivers used
in the EX4600 switch.
The optical transceivers installed in an EX4600 switch support digital optical monitoring
(DOM): you can view the diagnostic details for these transceivers by issuing the operational
mode CLI command show interfaces diagnostics optics
output for copper transceivers or transceivers not purchased from Juniper Networks.
The three tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimode fiber-optic (MMF) cables and copper interface support
over four-pair, Category 5 shielded twisted-pair cables:
Table 20 on page 50—Copper interface support and optical interface support for
Gigabit Ethernet SFP transceivers.
Table 21 on page 53—Optical interface support for 10-Gigabit Ethernet SFP+
transceivers.
Table 22 on page 58—Optical interface support for 40-Gigabit Ethernet QSFP+
transceivers.
NOTE: If you are using the QFX-QSFP-40G-ESR4 transceiver in a QSFP+
port and have configured the port to operate as multiple 10-Gigabit Ethernet
interfaces, you can use a fiber breakout cable to distribute the interfaces
to up to four 10GBASE-SR SFP+ transceivers. Juniper Networks does not
sell fiber breakout cables.
Chapter 8: Port and Interface Specifications
. The command does not give any
49