Juniper EX4600 Series Hardware Manual page 178

EX4600 Switch Hardware Guide
Related
Documentation
160
(Optional) Configure the name of the switch. If the name includes spaces, enclose
6.
the name in quotation marks (" ").
[edit]
root@# set system host-name host-name
Configure the default gateway.
7.
[edit]
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the switch management interface.
8.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION: Although the CLI permits you to configure two management
Ethernet interfaces within the same subnet, only one interface is usable
and supported.
NOTE: The management ports,
management panel of the EX4600 switch.
(Optional) Configure the static routes to remote prefixes with access to the
9.
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
Enable telnet service.
10.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to the EX4600 switch
through Telnet using root credentials. Root login is allowed only for SSH
access.
Commit the configuration to activate it on the switch.
11.
[edit]
root@# commit
Installing and Connecting an EX4600 Switch on page 139
em0 ( C0 ) and em1 ( C1 ) are found on the
Copyright © 2014, Juniper Networks, Inc.