Laser And Led Safety Guidelines And Warnings For Ex Series Switches; General Laser Safety Guidelines - Juniper EX4600 Series Hardware Manual

EX4600 Switch Hardware Guide
Related
Documentation

Laser and LED Safety Guidelines and Warnings for EX Series Switches

General Laser Safety Guidelines

98
Advarsel Unngå utsettelse for stråling, og stirr ikke inn i åpninger som er åpne,
fordi usynlig stråling kan emiteres fra portens åpning når det ikke er tilkoblet
en fiberkabel.
Aviso Dada a possibilidade de emissão de radiação invisível através do orifício
da via de acesso, quando esta não tiver nenhum cabo de fibra conectado,
deverá evitar a exposição à radiação e não deverá olhar fixamente para
orifícios que se encontrarem a descoberto.
¡Atención! Debido a que la apertura del puerto puede emitir radiación invisible
cuando no existe un cable de fibra conectado, evite mirar directamente a las
aperturas para no exponerse a la radiación.
Varning! Osynlig strålning kan avges från en portöppning utan ansluten
fiberkabel och du bör därför undvika att bli utsatt för strålning genom att inte
stirra in i oskyddade öppningar.
General Safety Guidelines and Warnings on page 91
Laser and LED Safety Guidelines and Warnings for EX Series Switches on page 98
Installation Instructions Warning on page 103
Grounded Equipment Warning on page 112
Laser and LED Safety Guidelines and Warnings for the QFX Series
EX Series switches and the XRE200 External Routing Engine are equipped with laser
transmitters, which are considered a Class 1 Laser Product by the U.S. Food and Drug
Administration and are evaluated as a Class 1 Laser Product per EN 60825-1 requirements.
Observe the following guidelines and warnings:
General Laser Safety Guidelines on page 98
Class 1 Laser Product Warning on page 99
Class 1 LED Product Warning on page 99
Laser Beam Warning on page 100
When working around ports that support optical transceivers, observe the following
safety guidelines to prevent eye injury:
Do not look into unterminated ports or at fibers that connect to unknown sources.
Do not examine unterminated optical ports with optical instruments.
Avoid direct exposure to the beam.
Copyright © 2014, Juniper Networks, Inc.