Figure 36: Removing A Transceiver From An Ex Series Switch - Juniper EX4600 Series Hardware Manual

Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
To remove an SFP, SFP+, XFP, or QSFP+ transceiver:
4.
By using your fingers, pull open the ejector lever on the transceiver to unlock the
a.
transceiver.
CAUTION:
ejector lever completely until you hear it click. This prevents damage
to the transceiver.
Grasp the transceiver ejector lever and gently slide the transceiver approximately
b.
0.5 in. (1.3 cm) straight out of the port.
CAUTION:
transceiver, do not touch the connector pins at the end of the
transceiver.
To remove a CFP transceiver:
Loosen the screws on the transceiver by using your fingers.
a.
Grasp the screws on the transceiver and gently slide the transceiver approximately
b.
0.5 in. (1.3 cm) straight out of the port.
CAUTION:
transceiver, do not touch the connector pins at the end of the
transceiver.
By using your fingers, grasp the body of the transceiver and pull it straight out of the
5.
port.
Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat,
6.
stable surface.
Place the dust cover over the empty port.
7.

Figure 36: Removing a Transceiver from an EX Series Switch

1— Ejector lever
Installing a Transceiver in an EX Series Switch on page 182
Pluggable Transceivers Supported on EX Series Switches
Chapter 21: Replacing Transceivers and Fiber-Optic Cables
Before removing the transceiver, make sure you open the
To prevent electrostatic discharge (ESD) damage to the
To prevent electrostatic discharge (ESD) damage to the
181