Zero Position Setting [Zerop] - Toshiba TS3000 Series Instruction Manual

series Robot Controller
Step 3: Displaying the next page
Press the [NEXT] key. The displayed information changes.
The page number is shown in the upper right of the screen.
Caution
 For details on displayed information, refer to the Simplified PLC Manual.

11.15 Zero Position Setting [ZEROP]

Functional Explanation
Sets the zero position (or origin).
This function is a maintenance function. For details, refer to the Maintenance Manual.
Operating Procedure
Step 1: Calling the [ZEROP] function
Press the [ZEROP] key among the utility function selection keys in the servo OFF state.
The ZERO POSITION screen is displayed.
TP3000 OPERATOR'S MANUAL
– 11-30 –
STE 85412