Toshiba TS3000 Series Instruction Manual page 183

series Robot Controller
Operating Procedures
Step 1: Stop execution 
Press the STOP switch in the case of the controller panel.
Then the STOP switch LED on the control panel goes on, and when the execution of
the instruction currently being executed is completed, the automatic operation stops.
When automatic operation is stopped, the RUN switch LED on the control panel goes
off.
Step 2: Stop execution 
Press the [STOP] key in the case of the teach pendant.
"STOP" is displayed in the STAT: field on the status bar of the teach pendant screen.
The display of the [STOP] key on the key board changes to the [RUN] key.
Cautions
• In the test operation mode, the "stop" external control signal is inoperative.
• To restart execution, press the [RUN] key.
TP3000
STOP SW
7-16
STE 85412