Remote Mode - Agilent Technologies E5052A Programmer's Manual

Overview of Remote Control
Sending SCPI command messages

Remote mode

The E5052A is not equipped for remote mode. Therefore, even if you send a GPIB
command, it cannot enter into remote mode automatically. There is no local key to release
remote mode.
If you need to prevent misoperation during remote control due to entry from the front panel
or mouse, lock the input devices by using the following commands.
• :SYSTem:KLOCk:KBD on page 368
• :SYSTem:KLOCk:MOUSe on page 368
48
2