Commands With Variable Parameters And/Or Setting Ranges Depending On Device Configurataion - Agilent Technologies E5052A Programmer's Manual

Commands with Variable Parameters and/or Setting Ranges Depending on
Commands with Variable Parameters and/or Setting Ranges
Depending on Device Configurataion
The table below lists the commands that have variable parameters and/or setting ranges
depending on the device configuration.
Table 7-1 SCPI Commands with Variable Parameters and/or Setting Ranges
Command
:SENSe:ATTenuation:LEVel
:SENSe:DCONverter:INPut
:SENSe:DCONverter:MANual:IFDelta
:SENSe:DCONverter:MANual:IFGain[1-2]
:SENSe:DCONverter:MANual:LO[1-2]:FREQuency
:SENSe:DCONverter:MANual:LO[1-2]:LEVel
:SENSe:DCONverter:MANual:MEXTernal[1-2]:BIAS:CURRent
:SENSe:DCONverter:MANual:MEXTernal[1-2]:BIAS:STATe
:SENSe:DCONverter:MEXTernal
:SENSe:FP[1-1]:DCONverter:FREQuency
:SENSe:FP[1-1]:DCONverter:SSEarch:EXECute
:SENSe:FP[1-1]:FBANd
:SENSe:FP[1-1]:POWer:INPut:LEVel:MAXimum
:SENSe:PN[1-1]:DCONverter:FREQuency
:SENSe:PN[1-1]:DCONverter:SSEarch:EXECute
:SENSe:PN[1-1]:FBANd
:SENSe:SP[1-1]:CARRier:FBANd
:SENSe:SP[1-1]:FREQuency:CENTer
:SENSe:SP[1-1]:FREQuency:STARt
:SENSe:SP[1-1]:FREQuency:STOP
:SENSe:TR[1-1]:NARRow:FREQuency:PREFerence
:SENSe:TR[1-1]:NARRow:FREQuency:TARGet
7
SCPI Command Reference
Device Configurataion
Depending on Device Configuration
Description
Sets/Reads the input attenuator level
Sets/Reads the signal supplied to the RF input port
Sets/Reads the differential frequency between CH1
and CH2 from the external mixer
Sets/Reads the IF gain of the external mixer
Sets/Reads the LO frequency of the external mixer
Sets/Reads the LO level of the external mixer
Sets/Reads the bias current to be supplied to the
external mixer
Sets the bias current supplied to the external mixer on
or off and reads its settings
Sets the use of the external mixer on or off and reads
its settings
Sets/Reads the input frequecny to be supplied to the
downconverter
Searches carrier signal and reflects the result to the
input frequency of the downconverter (No Query)
Sets/Reads frequency band
Sets/Reads the maximum input level of the
downconverter in order to determine the IF Gain
Sets/Reads input frequency of the downconverter
Searches carrier signal and reflects the result to the
input frequency of the downconverter (No Query)
Sets/Reads frequency band
Sets/Reads the carrier frequency band
Sets/Reads the center value
Sets/Reads the start value
Sets/Reads the stop value
Sets/Reads the phase reference frequency of the
narrowband modeǵ
Sets/Reads the target frequency of the narrowband
mode
403