Setting The Holding Force Parameters - DURKOPP ADLER D868 Service Instructions Manual

Icon

17.4.10 Setting the Holding force parameters

Various settings can be made for the holding force of the motor.
The possibilities are explained in more detail in the table.
Icon
130
Menu items
Bobbin rotation monitor
Remaining thread monitor limit
Remaining thread monitor
intensity
Menu items
Mode
Max. Current
Holding current of the motor
Response
Response time for the continuous current
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
Programming
Value range
• Value range
On/Off
Length
Seam length before the
bobbin rotation monitor
starts.
• Value range
000 – 255 [mm]
• Value range
0.0-4.0
Values only apply to
the remaining thread
monitor, not the SSD.
• Value range
0.0-4.0
Values only apply to
the remaining thread
monitor, not the SSD.
Value range
Holding Position
• Value range
On/Off/Holding
Position
Holding Position: the
sewing motor is always
regulated to this
position. It is not
possible to change the
position by using the
handwheel or setting
additional parameters.
only visible if the
parameter is activated
• Value range
00 - 50
only visible if the
parameter is activated
• Value range
000 - 100